Jacuzzi frame - Frame TOP Operation; Standby, Turning On, and Alarms; Hydromassage Jet Functions; Turkish Bath Activation

10/30
20
AL1_1
AL1_2
AL3
....
3
2
2
3
1
AL1_1
AL1_2
AL3
....
i
몇
몇
몇
몇
4
1
i
i
i
몇
Press to activate.
Select the symbol
desired.
Press to activate.
Make
sure that
the waterfall,
the whirlpool
jets and/or scale
removal cycle
are not active.
If the "wa-
ter-pitcher"
symbol ashes
for a few sec-
onds, or of it
is not possible
to activate the
function, see the
user manual.
It is possi-
ble to use
scented sticks
or essential oils
to perfume the
steam bath.
See the user
manual.
Press.
Select the steam sym-
bol.
Press to activate.
Press once again to disable.
Errors.
See the user manual.
Press to activate.
Press once again to disable.
The water will exit from the opening at the
top, located on the unit roof.
Make
sure
that you have
adjusted the
water temper-
ature.
Make
sure
that you have
adjusted the
water tem-
perature.
When the func-
tion is active,
press to activate
or disable.
JVEQITOP
Turkish bath Scale removal cycle
“Shiatsu”
“Cervical/lumbar”
“Sequential”
On the control panel, the arrows on the right, are used
to select the main unit functions. The “<” and “>” keys
enable access to the various menus and sub-menus;
the "on/o" key conrms the selection.
Press
to activate
If no key is pressed for
approximately 30 sec-
onds, the system enters “stand
by”.
ERRORS
See the user manual
Press the relative key to acti-
vate the electronic function
desired.
Press to activate the elec-
tronic functions.
See the user manual
to modify the time
and the display contrast.
When pressed, the
key starts to ash
and the alarm indicator
is immediately activated.
Press to activate.
Press once again to disable.
“Stand by”
“Stand-by”"Turning on"
"Alarms"
Waterfall Turkish bath Hydromassage jets