Jacuzzi frame - Hydromassage Jet Types; Shiatsu, Cervical;Lumbar, and Sequential Jets; Turkish Bath Details; Temperature and Duration Settings

20
AL2
20
20
3 sec.
4 sec.
5 sec.
1 sec.
2 sec.
2
1
2
1
30°C
2
3
1
2
i
i
i
1
3
1
2
15 min
15 min
15 min
45 min
15 min
i
“Shiatsu”
It is possible to personalise
the function by excluding
one or two pairs of jets so that the
massage is concentrated in cer-
tain areas rather than others.
“Cervical/lumbar”
“Sequential”
Selects the type of massage.
Press to activate
(or stop).
It is possible to vary the jet pair activation speed.
Press the “<” key to decrease or the “>” key to
increase the speed.
TONIC RELAX
CERVICAL
LUMBAR
It is possible to vary the jet pair activation speed.
Press the “<” key to decrease or the “>” key to
increase the speed.
Selects the type of massage.
Press to activate
(or stop).
Press to stop
(or reactivate).
(continuous jet)
The jet pairs are activated (represented
by 4 half-circles) from the bottom up-
ward in sequence. Each pair remains
active for 3 seconds.
When the keys are pressed, an arrow ap-
pears. Move the arrow to the pair which is
to be disabled.
Press to conrm
Access
is pro-
vided to the
"Turkish bath"
function.
If a few seconds
pass without
pressing any
key, the num-
ber under the
drops will ash.
Press the “on/
o” key to re-
turn to temper-
ature adjust-
ment.
It is possible to vary the selected value, even when the function has been
activated, by pressing the “on/o” key (the number ashes) and by using
the “<” or “>" key.
If you wish to carry out a Turkish bath using the preset values, do not press any keys.
40-45° C (Preset value)
35-40° C 45-48° C
It is possible to set dierent
values where desired.
Press to conrm this value (a line
under the symbol will appear).
Turkish bath duration
(in minutes)
Press to conrm.
Where desired, it is possible to modify
the duration (minimum of 5 min-
utes, maximum of 45 minutes).
The steam will be released
from the nozzles (dispenser)
after a couple of minutes,
and hence, the Turkish bath
countdown duration com-
mences. The illuminated
sectors will turn on and o
in succession. Upon reach-
ing 30° C the sectors all re-
main lit.
ATTENTION!The emerging steam
has a temperature close to 100°C!
Do not rest legs on the steam outlet,
keeping them at least 40 cm from the
steam nozzles.
Upon com-
pletion of the
function, an acous-
tic signal sounds
and the "waterfall"
key ashes. It is
possible to activate
a cold water jet,
which is released
from the roof open-
ing, when pressing
this key within a
few seconds. Do not
press this key if you
do not intend to use
this function, At this
stage, the steam
generator washing
cycle will begin;
during this time, it is
not possible to acti-
vate the hydraulic
functions up until
the point where the
"Turkish bath" key
stops ashing.
Temperature
Duration
Press to stop
(or reactivate).