Jacuzzi frame - Jet Sequence Operations; Relax, Tonic, Cervical, Lumbar Sequences

i
15 min
15 min
15 min
15 min
45 min
15 min
“Relax”
“Tonic”
“Cervical”
“Lumbar”
Press to select the "Relax" massage.
Press again to stop (or reactivate).
Press 2 times (within 3 seconds) to select the
"Tonic" massage.
Press again to stop (or reactivate).
Press to select the "Cervical" massage.
Press again to stop (or reactivate).
Press 2 times (within 3 seconds) to select the
"Lumbar" massage.
Press again to stop (or reactivate).
The key lights up and the LED
light next to it also lights up to
indicate that the "Relax" mas-
sage has been selected.
The key lights up and the LED
light next to it also lights up to
indicate that the "Tonic" mas-
sage has been selected.
The key lights up and the LED
light next to it also lights up
to indicate that the "Cervical"
massage has been selected.
The key lights up and the LED
light next to it also lights up
to indicate that the "Lumbar"
massage has been selected.
ATTENTION!
The emerging steam
has a temperature close to
100°C! Do not rest legs on
the steam outlet, keeping
them at least 40 cm from the
steam nozzles.
After a couple of minutes, the steam starts to exit
from the nozzles (dispensers) hence the count-
down of the duration of the Turkish bath begins.
Upon completion of the func-
tion, an acoustic signal sounds
and the "waterfall" key flashes. It is pos-
sible to activate a cold water jet, which
is released from the roof opening, when
pressing this key within a few seconds.
Do not press this key if you do not in-
tend to use this function, At this stage,
the steam generator washing cycle will
begin; during this time, it is not possible
to activate the hydraulic functions up
until the point where the "Turkish bath"
key stops flashing.
Sequence of jets from the top down-
wards
Sequence of jets from the bottom
upwards
Pair of upper jets
Pair of lower jets