Control Panel
A. Display: it shows you the current water
temperature, the water temperature set point,
selected skimming/heating mode, and error messages.
B. ( + ) Button: increases water temperature set point.
C. ( - ) Button: decreases water temperature set point.
The range of temperature adjustment goes from
18 to 40 °C. Factory default setting is 38 °C.
D. Light button: if you press the light button, you can switch on
and off the underwater light.
If there is a LED lighting system you also can switch it on with that button.
E. Pump 1 button: switches pump 1 on and off. Press once for low speed; press a second time for high speed;
press a third time to switch it off.
F. Pump 2 button (only for models with two pumps): switches pump 2 on and off. Press once to switch it on;
press twice to switch it off.
G. Heat Indicator: it`s on if the heater works.
WARNING!
►Persons with heart diseases, diabetes, high or low blood pressure or other health problems are not allowed to
use the hot tub without consulting their doctor.
►Do not use the hot tub after drinking alcohol or taking medicines which cause drowsiness or raise/lower the
blood pressure.
►Do not use the hot tub in extreme weather conditions (during storms etc.).
►Be very careful when getting in and out of the hot tub. All of the surfaces are
slippery.
►During use of the hot tub, do not use objects that can break or fragile objects.
►During use of the hot tub, you must keep your head, body and clothes at a distance of at least 40 cm from the
suction nozzles; long hair must be tied back and secured in place.
►Do not use electrical equipment (radios, hair dryers) near the hot tub if it is not empty.
►Do not remove the protective grids from the suction nozzles.
To Next Page
Loading...
Need help?
General
