Page 79
J-400
a programmed lter cycle. These pumps draw water from footwell suction
tting and through a secondary water polishing bag lter and additional
lter. The exclusive footwell “sweeper” suction tting enhances ltration
in the footwell area by creating a “swirling” water motion to maximize
particle agitation and pickup.
A.
To ensure optimum performance:
1. The ProClarity™ lter cartridge (A) must be
cleaned every three months and replaced every
two years.
2. The ProClarity Depth lter (B) must be replaced
every 3 to 4 months.
3. The ProClarity lter canister (C) can be rinsed
when the lters are cleaned.
4. For J-460/J-465/J-470/J-480 Models: The
secondary ProClear Plus polishing lter bag (D) should
be checked and emptied monthly.
5. For J-415/J-425/J-495 Models: The ProClarity debris
bag (F) should be checked and emptied monthly.
6. The ProClear II skimming lter cartridge (E) must be cleaned every
three months and replaced every two years.
To accomplish this, refer to the following lter cleaning procedure.
Note: Do not attempt to wash the ProClarity depth lter (B) and the
ProClear/ProClarity debris bag (D/F) or it will come apart!
B. For J-460/J-465/J-470/J-480 Models
DANGER: TURN POWER TO SPA OFF! TO DECREASE RISK OF
DAMAGED OR ALTERED!
1. Remove power to the hot tub before removing the skimmer (A) or
lter bag cover (B).
2. Remove the polishing bag lid (B) by rotating it counterclockwise
approximately 5 degrees until you feel it unlatch.
3. Remove the polishing bag by reaching into the lter bucket and
gently pulling upward on the blue lter ring (check and empty lter
monthly.) Located below the bag is a ProClear lter. Remove the
A
C
E
D
F
To Next Page
Loading...
Need help?
General
