Page 70
J-400
The clean-up cycle occurs once per day in all Heating modes at 12:00
(noon) for two minutes. This is not user programmable. Each jets pump
activates for one minute to circulate any water in the plumbing unless
a pump has just nished a 20 minute time out, it will not automatically
activate for the clean-up cycle. Be aware, the factory programmed
clean-up cycle cannot be canceled or altered!
12.5 Programming the
CLEARRAY™ timer
1. Use the Quad Keypad down button
to select “UV Light.” After the “UV
Light” selection is active, press the
Splash button to activate the “UV
timer” (Figure S).
2. Press the Left button on the Quad
Keypad to set the “UV timer” to 365
days (Figure T).
Note: The UV timer counts down by
days not usage. The days are store in
memory if the power is interrupted.
3. When the timer expires, the “Bulb
Expired!” message will appear on
the Main Menu display. The UV bulb must be replaced
(page 89) and the timer must be reset. Just follow
the instructions above to reset the UV timer.
Note: When the timer expires, the indicator light will turn red. The bulb
must be replaced and the timer reset.
12.6 Setting the Check Filter
Reminder
1. Use the Quad Keypad down button to
select Filter. After “Filter” selection is
active, press the Splash button to
access the “set lter timer” (Figure
U).
2. Press the Left or Right button on the
Quad Keypad to scroll the number
of days you would like the reminder
to appear so the lters and polishing
bag can be cleaned or replaced
(Figure V).
Press to
set filter or UV timer
Filter
OFF
SETTINGS 1
1
2
Heating
UV Light
0 Days
Figure S
Figure T
OFF
Heating
Filter
SETTINGS 1
1
2
UV Light
365 Days
Figure U
Press to
set filter or UV timer
SETTINGS 1
1
2
Heating
UV Light
0 Days
Filter
OFF
Figure V
Press to
save settings
Heating
UV Light
365 Days
SETTINGS 1
1
2
0 Days
Filter
To Next Page
Loading...
Need help?
General
