29
ROUTINE MAINTENANCE
XKeep the spa covered at all times when not in use. In this way,
along with keeping the water from getting dirty, you will also
avoid heat loss and evaporation.
XPeriodically clean the hydromassage and suction nozzles.
CAUTION
After cleaning, immediately put the grilles of the aspira-
tion nozzles back in place. These safety devices must co-
ver the suction intake in order to reduce the risk of hair
or other body parts getting caught. The intakes must be
cleaned with the bath empty.
Remember to ret all the parts before re-lling the spa.
The suction intake grilles must be checked at least once
a week.
XRegularly clean the headrests using a cloth, soap and water.
You are advised to use protective products to increase water re-
sistance and maintain their shiny appearance.
QMaintenance of cartridge lters
The lters must be periodically cleaned according to the amount
of use of the spa and replaced when necessary
The cartridges are available from Jacuzzi® authorised dealers
and Service Centres.
XCheck the skimmer at least once a week to remove any sedi-
ment such as leaves, hair, etc.
XWith normal use of the spa, it is advisable to clean the lters
at least once a week. If necessary, the lters should be cleaned,
because clogged lters cannot keep the water clean. They also
compromise proper operation of the system.
XTo clean the lters, remove the skimmer cover (C), unscrew
the lter baskets and take them out.
1
2
3
4
XSeparate the lter folds and clean with a jet of pressurised water.
If the lter is clogged, it is advisable to use specic products for
the removal of encrustation and grease, available from authori-
zed Jacuzzi® dealers and service centres.
XRet, repeating the operations in reverse order.
CAUTION
After cleaning the lters, do not re-start the spa until
you have re-assembled all components.
QMaintenance of thermal cover
Fabric
XRemove the cover from the support frame and lay it on a
straight surface.
XDampen the fabric with clean water. For a plastic cover, you
can proceed directly with cleaning.
XEvenly spread a diluted solution of neutral soap on the sur-
face.
XLet the solution stand for 2-3 minutes, depending on the
degree of dirtiness.
To Next Page
Loading...
Need help?
General