What to do if my Jade Tanning Beds unit is activated but nothing happens?
If your Jade Tanning Beds unit activates but nothing occurs, first ensure the unit is properly connected to the power source. If it is, try restarting the timer. Also, verify that the unit is plugged in correctly. If problems persist, a certified technician should check the voltage reading.
Why is my Jade Tanning Beds unit too hot?
If your Jade Tanning Beds unit seems too hot, it could be due to a couple of reasons. First, check that the fans are not obstructed by anything, including dust. Second, the room may be too small for the unit; verify that the room size meets the requirements specified in the manual.
What to do if the facial tanner on my Jade Tanning Beds does not light?
If the facial tanner on your Jade Tanning Beds unit isn't lighting, make sure the face tanner switch is in the 'On' position, and then power cycle the unit. If the lamp is defective, replace it. If you've been switching the tanner on and off rapidly, wait a few minutes (approximately 3 minutes) for it to cool down before switching it back on.
How to fix individual lamps that don't light in Jade ProSun Jade 32 Tanning Beds?
If individual lamps in your Jade Tanning Beds unit aren't lighting, try the following: 1. Ensure the lamps are properly secured in their sockets by turning each lamp in its socket until it illuminates. 2. Replace any lamps or starters that are defective. 3. If the lamps' lifecycle has ended, replace them.
Why is the room temperature abnormally warm when using Jade ProSun Jade 32?
If the room temperature becomes abnormally warm when using your Jade Tanning Beds unit, it might be because the unit is too close to the wall. Pull the unit away from the wall, leaving at least 10-12 inches of space.
What to do if the canopy of my Jade ProSun Jade 32 does not stay open?
If the canopy of your Jade Tanning Beds unit doesn't stay open, check that the shocks are installed according to the assembly instructions in this manual.
What to do if the acrylic on my Jade ProSun Jade 32 Tanning Beds is cracked?
If the acrylic on your Jade Tanning Beds unit is cracked due to damage from user actions or cleaning, you can contact ProSun for a replacement. A non-skilled person can replace the acrylic.
Explains the purpose of the tanning bed, its indications, and key warning symbols.
Provides instructions for setting up the unit and required environmental parameters.
Outlines the process for initial setup and handover by a certified technician.
Lists critical safety precautions and conditions for which use is contraindicated.
Specifies operational limits, such as ambient temperature and commercial use rules.
Explains how tanning works and provides a schedule based on skin type.
Lists common error codes (E1, E2, E3) and recommended actions.
Outlines safety rules for maintenance and a preventative care schedule.
Provides a table of common issues, probable causes, and possible solutions.
Details longevity, disposal, and technical modifications for unit components.
Covers warranty period, coverage, claim procedures, and limitations.
General| Brand | Jade |
|---|---|
| Model | ProSun Jade 32 |
| Category | Tanning Beds |
| Language | English |
To Next Page
