JIF-2002 WEIGHING INDICATOR&CONTROLLER
20
STEP 10: When press a key, the key number will show in the middle of
the screen. The lower side from left to right: KEY 001∼KEY
008. The upper side from left to right: KEY 009∼KEY 010.
If the key number does not match, it suggests an error
occurred. Please contact us.
STEP 11: Finish checking, display END .
Slide the SET switch to the original side.
※ Above testing if any FAIL or error shows on the screen,
please contact us or distributors.
4-2 Functions
STEP 1: Turn the Power Switch OFF on the Rear Panel, Slide the SET
switch to the set side.
STEP 2: Turn the power supply ON, the display will show blinking
SELECT.
STEP 3: Press TARE key and screen will show blinking FUNC and
blinking F000 afterward.
STEP 4: Please press or key to move through the function
category (F000, F200, F300, F400 or F500). Then press the
↵ Key to enter the category. Use the or key to choose
specific function (F000 ~ FC02, F100 ~ F107, F200 ~ 204,
F400 ~ F402 or F500 ~ F506). In each function, please use
or key to set function value. If you want to return to
previous function category, please press ESC key, or press
↵ key to enter.
L If any errors occurred, please check if each setting value within
effective range.
L note：● Indicates initial factory setting.
To Next Page
Loading...