3
Important safety instructions
Please read this before using your product
Do not attempt to remove any screws or panels.
There are no user serviceable parts inside.
Do not operate this unit if the cord or plug is damaged.
Please refer to a service centre for examination and repair.
To avoid electric shock never touch the cord or socket with
wet hands.
Never operate the unit when empty - damage may occur.
Keeptheunitunpluggedbeforefilling.
Do not use boiling water as damage to the unit may occur.
Do not exceed the “MAX” marking on the inside of the tank.
Always unplug the unit immediately after use and before
emptying the liquid.
Do not operate the unit next to heat sources such as
radiators.
Operate on a dry level surface.
To avoid electric shock do not immerse the unit into water or
other liquid. The unit should not be exposed to dripping or
splashingandnoobjectsfilledwithliquidsshouldbeplaced
on top of it. When emptying, always pour liquid away via the
back, avoiding the ventilation slots / power inlet on the sides
and control panel on the front face.
Donotfillthetankwithabrasivesorcorrosivechemicals
(such as solvents, acids or alcohol).
Repeated cleaning cycles will enhance the cleaning effect.
Never leave the unit unattended when the heater is switched on.
Always unplug and clean the unit when left overnight.
To Next Page
Loading...
Need help?
General
