4. Turn the power switch on. Press Temp button to set the water temperature to 45ºC (113ºF). Press Heater
button to turn on the heater, flashes. Close the lid. LED
lights up. When water reaches the set
temperature, dims, indicating the heater is turned o.
5. Press Time button to set the timer to 15 minutes. Press On/O button to start cleaning. Grease will dissipate
and appear to be like black smoke in the water.
6. When it stops, open the drainage valve to release the dirty water. Close the valve afterwards.
7. Clean the tank and add fresh water. Wash the items for another 3 minutes to remove the residual debris
and the detergent.
Silver, copper or brass items with oxidation which has
darkened the items will need special cleaning.
Suitable Locations: silver, copper or brass product
manufacturers, home, shooting clubs.
Cleaning Method: Put the items in the basket and then in
the tank, add water to a level between “MIN” and ”MAX” and
above the area to be cleaned.
2. Add special solution (SeaClean2) that can remove silver
or copper oxidation according to the ratio recommended
(typically 1:10), Use special solutions according to the
instructions for brass cartridges.
3. Turn the power switch on. Press Temp button to set the
water temperature to 50ºC (122ºF). Press Heater button to turn
on the heater, flashes. Close the lid. LED
lights up
indicating the percentage range of the set temperature being
reached. When water reaches the set temperature, dims,
indicating the heater is turned o.
4. Press
h/min button to set solution usage time. Each pressing increases the time by 20 minutes. Press
button to reduce the time by 20 minutes each time. Common time is or . Refer to the instruction from
the solution manufacturer.
5. Press Time button to set the timer to 15 minutes.
6. Press Function button to select the degas function. button illuminates. Press On/O to start degassing.
After 90 seconds it changes over to normal cleaning automatically.
7. When it is done, remove the basket and the items. Rinse the items with tap water or follow steps 6 and 7 in
the Enhanced Cleaning section.
Warm water and dishwashing liquid can soften grease and improve cleaning eciency.
SPECAL CLEANING
The heater has dual protection. It will be turned o automatically after 50 minutes.
During cleaning, debris will come o the items like “smoke”. Water will become murky. This method will
remove silver or copper oxidation and debris in the decorating patterns and crevices and make the
items like new again.
13
To Next Page
Loading...
Need help?
General
