James WEDGE Series User Manual

INSTALLATION GUIDE
®
Installation guide for James Wedge Series Speaker
Take the bracket off of the back of the speaker
by using your hand, and pulling one side of the
bracket out.
1
3
If the wires are in the wall, then run it through
the bottom slots on the bracket (top photo).
If the wire is in the ceiling, then run the wire
through the top slots of the bracket (bottom
photo).
Next, determine if your wires are located in the
ceiling or the wall.
2
If the speaker is being installed flush with the wall
and ceiling, then install all nine screws to secure
the bracket.
4
Now connect your wires to the speaker. (Red to
red, and black to black)
6
5
The bracket can also be secured to a wall
using just six wall screws.
WEDGE SERIES INSTALLATION GUIDE

James WEDGE Series Specifications

General

Brand	James
Model	WEDGE Series
Category	Speakers
Language	English

Summary

James Wedge Series Speaker Installation Steps

Bracket Preparation and Wire Management

Detach speaker bracket, determine wire location (ceiling or wall), and route wires through appropriate bracket slots.

Bracket Securing and Electrical Connection

Secure the bracket using wall screws and connect the speaker wires to the corresponding terminals (red to red, black to black).

Speaker Mounting and Final Adjustments

Mounting the Speaker and Ensuring Flush Fit

Mount the speaker onto the bracket by guiding the upper channel, then adjust for a flush fit with the wall/ceiling.

Final Securing and Installation Video

Tighten the set screws using the provided hex key and access the installation video via QR code.