34
EXO BASIC
1a Extract the ISOfix fasteners (10) turning the
handle (12) found on the front of the base.
1b Guide both fasteners to the axles and press
until both sides are locked into place, two
green signals will appear on the fasteners (10)
when they are correctly fastened. If one or both
of the signals are red, try again.
1c Turn the handle (12) in the opposite direc-
tion so the seat adjusts itself against the bac-
krest of the vehicle.
1d Insert the support leg accessory until it rea-
ches the end and you hear it click.
Together with the instructions, you will find a list of vehicles that shows which models are compatible
with SEMI-UNIVERSAL installation. If your car is not on the list get in touch with the retailer.
1 Installation with the ISOFIX fasteners + the support leg. SEMI-UNIVERSAL
1e Adjust the height of the support leg so that
it is supported by the floor of the vehicle.
1f To remove the Support Leg accessory press
the buttons found underneath the footrest and
pull outwards.
To remove the seat when using ISOfix:
1g Release the fasteners by sliding both unloc-
king buttons (11) inwards. The signals on the
fasteners (10) will turn red.
1h Remove the seat. The ISOfix fasteners can
be stored in the base by turning the handle
(12).
For correct installation follow the steps below:
To Next Page
Loading...
