Janser Tiger - Wheels; Routine Maintenance; Sanding Chamber; Rollers

TIGER
BELT-SANDER FOR WOODEN FLOORS
ED 95
PG. 14/16
_______________________________________________________________________________________________
INSTRUCTION MANUAL
ROUTINE MAINTENANCE
In order to keep the machine in good working condition, it is necessary to maintain the following items
periodically.
SANDING CHAMBER
Periodically vacuum-clean the sanding chamber of dust in order to prevent interference with correct
tensioner operation.
ROLLERS
Periodically check the external surface of the tensioning and sanding rollers. Remove any dirt.
WHEELS
Periodically remove dirt from the machine body and wheels. Dirt can cause ripples on the sanded
surface.
DUST BAG
Remove the bag and shake it vigorously to empty out the sanding dust. Turn the bag inside out and
wash it in a washing machine in cold water in order to prevent the pores from blocking and its ability
to collect dust from decreasing.
BELT TENSION
Periodically check the belt tension. For adjustment procedures, see pg. 10.
BALL BEARINGS
Check the ball bearings periodically for wear or damage according to the following schedule:
Wheels after the first 2500 hours.
Belt stretching pulley after the first 2500 hours.
Impeller shaft after the first 2500 hours.
Tensioning rollers after the first 2500 hours.
Sanding roller after the first 5000 hours.
Motor shaft after the first 5000 hours.
SPARE PARTS
Always use original JANSER spare parts. The guarantee and consequent responsibility are forfeited if
non-original JANSER spare parts are used, and if repairs and adjustments are carried out by
unauthorized personnel.