Need help?Do you have a question about the Janus 3M Novec 1230 and is the answer not in the manual?
General| Agent Type | Novec 1230 |
|---|---|
| Cylinder Material | Steel |
| Cylinder Color | Red |
| Extinguishing Agent | Novec 1230 |
| Fire Class | A, B, C |
| Discharge Time | 10 seconds |
| Actuation Method | Manual |
Details compliance requirements for FM Approval.
Describes Novec 1230 fluid properties, composition, and environmental impact.
Outlines essential safety guidelines and training requirements for cylinder filling.
Describes the cylinder, its superpressurization, and fill density.
Explains the function and location of the rupture disc for emergency pressure relief.
Details the mechanism and function of the liquid level indicator.
Describes the dip tube's purpose and connection to the cylinder valve.
Explains the differential pressure operated valve controlling fluid release.
Lists and describes the six key features of the Sv Series cylinder valve.
Lists and describes the six key features of the Mv Series cylinder valve.
Lists and describes the five key features of the Lv Series cylinder valve.
Explains the purpose and types of fill adapters for cylinder connection.
Details the Sv Series fill adapter, its connections, and check valve.
Details the Mv Series fill adapter, its connections, and check valve.
Details the Lv Series fill adapter, its connections, and check valve.
Describes the assembly of fittings and valves connecting fill station to cylinder.
Details the pump connection port and its function in the fill assembly.
Details the cylinder connection port and its function in the fill assembly.
Details the gauge connection port and its function in the fill assembly.
Details the nitrogen pressurization port for superpressurizing the cylinder.
Describes the assembly for regulating and supplying nitrogen for pressurization.
Explains the valve closing line for seating the cylinder valve piston.
Explains the line used to supply nitrogen for cylinder pressurization.
Describes the adapter used to close the cylinder valve with nitrogen pressure.
Discusses supply tank types (drums, IBCs) for Novec 1230 fluid.
Details handling IBC containers and the need for nitrogen pressurization.
Describes the kit for connecting nitrogen supply to an IBC container.
Explains the regulator used for nitrogen supply to IBC containers.
Discusses using supply drums and the need for filtered air with desiccant.
Describes the equipment used to pump liquid agent into the cylinder.
Explains the function of liquid/moisture indicator, inlet, and discharge pressure gauges.
Details the selector knob for controlling agent flow direction.
Explains the pump control knob for adjusting fill station pump speed.
Describes the knob for switching between agent and nitrogen fill modes.
Details recording cylinder information and initial weighing before filling.
Outlines the process for filling the cylinder with Novec 1230 fluid.
Describes using nitrogen to seat the cylinder valve piston before disconnecting.
Details the procedure for weighing the cylinder after filling to determine agent amount.
Explains how to retrieve excess agent if an overfill occurs.
Details the process of superpressurizing the cylinder with nitrogen.
Outlines final steps including standing, leak checking, and recording weights.
Describes the methods and tools for testing cylinder assemblies for leaks.
Details inspection and maintenance of piping and nozzles for damage.
Outlines the overall process of recharging a system cylinder.
Steps for safely removing a cylinder from the system for recharge.
Procedures for cleaning and servicing the cylinder valve assembly.
Summarizes the recharge process, referring to Section 4 and installation manual.
To Next Page