Need help?Do you have a question about the Janus PBX and is the answer not in the manual?
Instructions for installing the box-less PNB model phone.
Instructions for installing the box style PBX model phone.
Instructions for installing the flush mount PSS/PSL models.
Instructions for installing the surface mount PSM model phone.
Program the phone by calling its number from another phone.
Program the phone using the on-board keypad and a battery.
Disables the dialer from automatically dialing a phone number.
Disables the voice prompt saying "Elevator call at the tone..."
Disables voice prompt and delays location message playback.
Enables the default voice prompt message for elevator calls.
Controls AUX1 output behavior based on LED status or VCC mode.
Used for phone line monitoring; closes if line drops below 2 volts.
To Next Page
General
