2 Speed Boat Trailer Winch Owner’s Manual
8
Winches are not intended (1) for the movement of people and (2) as a load securing device for boats on trailers
(T) +61 (0)8 8243 9100 (F) +61 (0)8 8243 9185 Toll Free Sales: 1 300 135 935
Email: sales@advansa.com.au Web: www.advansa.com.au
After A1 or A2 - Remove the winch from the foundation.
• Check fasteners for stripped threads, wear, bending, and other damage.
• Check the frame (winch body) for bending, distortion, cracks, and other damage. A
bent frame is caused by overloading, and is a sign that your application may require a
winch with a larger load rating.
Move the drum with your hands.
• Check for excessive movement indicating worn or loose gears, bushings, or shafts.
• Disassemble the winch if necessary. Inspect gears, pins, springs and shafts for wear,
corrosion, distortion, and other damage
Fasten the winch securely to the foundation.
Install the wire cable / webbing / fibre rope.
Test winch performance by operating the winch with a test load equal to the load rating.
• Listen for unusual noises, and look for signs of damage as you operate the winch.
• Make sure the winch cable winds evenly and tightly onto the drum. If it is loose or uneven, rewind it before continuing.
• Make sure the handle moves freely in both directions.
• Make sure the Pawl (ratchet) engages and disengages completely.
Completely correct all problems before continuing. Use the Troubleshooting Chart (below) to help determine the cause of certain
problems.
Troubleshooting Chart
problem cause correction
handle turns, drum doesn’t turn • loose or broken pins inspect winch, repair as necessary
• loose, stripped or broken gears or pinions inspect gears / pinions and repair as necessary
handle turns hard or not at all • pawl (ratchet) on winch engaged disengage winch pawl (ratchet)
• load too heavy lighten load
• pins loose or broken on winch inspect winch, repair as necessary
• drum shaft broken or seized inspect, repair or replace as necessary
overheating • operated too long without rest allow to cool
• load too heavy lighten load
• poor lubrication inspect and lubricate as necessary
• bushings seized up inspect and replace as necessary
unusual noises
high pitched squeak • poor lubrication inspect and lubricate as necessary
grinding noise • contaminated lubrication clean and relubricate winch
rattling noise • loose bolts, set screws or other fasteners tighten all bolts and other fasteners
Warranty
Please note that all goods are supplied by Advansa Pty Ltd to the Purchaser for use only in applications and purposes
for which they were originally designed. Advansa Pty Ltd is not liable for any consequential loss whatsoever from
improper or inappropriate use of the goods supplied, where the goods are used for purposes beyond or outside of the
scope of application for which they were designed and which exceeds their designed performance limit. At all times
please consult Advansa Pty Ltd if unsure of the suitability of the goods for your intended application.
Advansa Pty Ltd Winch Warranty Policy: The Warranty is for the period of twelve months on Jarrett winches /
cranes providing it is used for the purpose that it was designed for. Any modifications or misuse of the winches /
cranes will void the warranty. Winches / cranes will be repaired under warranty providing proof of purchase is supplied.
No credits or replacements will be issued except with approval from Advansa Pty Ltd.
To Next Page
Loading...