This auxiliary switch is a component of the JASCO
Z-Wave
®
lighting control system and is designed to
work with all Jasco branded Z-Wave Dimmer and on/
off switches. Use one auxiliary switch for 3-way control
such as the top and bottom of a staircase (1 load/light & 2
switches) with one of the above Z-Wave devices. Two or
three auxiliary switches can be used with these dimmers
and switches to create a 4-way (1 load/light & 3 switches)
or 5-way (1 load/light & 4 switches) lighting system.
The 45710 auxiliary switch is not Z-Wave enabled
and must be used exclusively with one of the Z-Wave
devices listed above. It is not designed for stand-
alone use to control an electrical load. It does not
have Z-Wave functionality and does not act as a
repeater in your Z-Wave control network.
This switch communicates with the Z-Wave enabled
switch through the traveler wire, providing manual On/Off/
Dim control of the connected lighting (through the active
Z-Wave switch) and synchronization of the lighting status
(On/Off/Dim level) between the switches.
There are no user serviceable parts in this unit.
To Next Page
Loading...