JASMINER X16 - Use and Setup; Wiring and Inspection; Configure the Machine

JASMINER X16 High-Throughput Power Server User Manual
8
IV. Use
and
Set up
1. Wiring and inspection
A) Network cable connection: insert the RJ 45 crystal head into the Ethernet
port(shown as ETH on machine back), pay attention to the direction when
plugging the cable, and please insert the crystal head in place;
B) Power cable connection: Please connect the 120V-240V AC power supply to
operate correctly.
2. Configure the machine
Configure the machine by JASMINER IP group control software.
 Download the IP group control management software from following path:
JASMINER website → support → Installation → guide & firmware → other →
software & firmware;
 Install the JASMINER program (IP group control management software) on
Windows OS, double-click to run, and note that the computer needs to be in
the same network segment with the machine;
 After successful installation, see the figure below, click "generate" → "scan" in
the software interface to scan machine's IP, the the relevant information will
automatically pop up after scanning is complete.