AT-596
[RE5F22A]
DTC P0882 TCM POWER INPUT SIGNAL
Revision: November 2006 2006 Altima
4. CHECK DTC
Check again. Refer to AT-592, "
DTC Confirmation Procedure" .
OK or NG
OK >> INSPECTION END
NG >> GO TO 5.
5. CHECK TCM
1. Check TCM input/output signal. Refer to AT-459, "
TCM Input/Output Signal Reference Values" .
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.
Component Inspection
ECS009IE
A/T PV IGN RELAY
1. Apply 12V direct current between A/T PV IGN relay terminals 1
and 2.
2. Check continuity between relay terminals 2 and 3.
3. If NG, replace A/T PV IGN relay.
Condition Continuity
12V direct current supply between terminals 1 and 2 Yes
OFF No
WCIA0555E
To Next Page
Loading...