ENCODING INSTRUCTION
Set up step-by-step: switch on both receiver and all indicators shall be
connected. Press and hold “S” setup button (E) on receiver back side.
After one beep (or one vibe when vibes mode is on) which lasts about 2 seconds
move indicator roller immediately and then release “S” button. Check
connections between setup indicator and receiver and follow the same way with
other indicators.
Press and hold “S” setup button (E) longer – about 7 seconds until two beeps (or
two vibes when vibes mode is on) to cancel all settings/connections.
NOTES
Don’t put device into water.
Any repairs should be made by Authorized Service.
Do not attempt to disassemble the bite alarm yourself.
If the bait indicator is not in use for some time, remove batteries.
Clean the bite alarm with a slightly damp cloth. Do not use soap or solvent.
To Next Page
Loading...