Jayco 2014 JAY FLIGHT User Manual

SECTION 4 TOWING & SET-UP JAYCO TOWABLE
4-18 JFB/JFD
Fig. 4.8 Detachable Hitch
4. Coil wires up and place behind front crossmember.
5. Raise tongue up with tongue jack.
6. Place two jack stands (3 ton minimum rating each, one on each side of the
trailer) approximately 4’ behind the front crossmemeber under the main I-
beam.
Fig. 4.9 Jack stands
7. Lower frame down onto jack stands.
8. Place another 2 jack stands (3 ton minimum rating each, one each side of
tongue) under tongue between 2 tongue connection plates.
9. Remove tongue from trailer by removing ¾” bolts and nuts (4 per connection
plate, 16 total).
To reinstall the hitch, reverse these steps. (tighten the bolts to 60-70 ft/lbs torque).
It is your responsibility to take your travel trailer to the dealer for warranty or
service repair (please refer to the Limited Warranty in Section 1).
Step 9
Step 7
Electrical wiring & safety
break-a-way switch

Jayco 2014 JAY FLIGHT Specifications

General

Category	Motorhomes
Year	2014
Make	Jayco
Model	JAY FLIGHT
Length	Varies by model
Width	Varies by model
Height	Varies by model
Dry Weight	Varies by model
GVWR	Varies by model
Fresh Water Capacity	Varies by model
Gray Water Capacity	Varies by model
Black Water Capacity	Varies by model
Sleeping Capacity	Varies by model
Number of Slideouts	Varies by model