SECTION 4 TOWING & SET-UP JAYCO TOWABLE
4-8
EMERGENCY STOPPING
Always carry road flares or reflective warning signs to display if necessary. Pull off
the roadway as far as possible for emergency stopping or tire changing. Turn ON
your RV hazard warning flashers. If traveling at night, use three red warning
indicators such as flares, reflectors or lanterns, as follows:
1. Place the first warning indictor on the traffic side of the RV, directed at the
nearest approaching traffic.
2. Place the second warning indicator 100 feet behind the RV in the center of
the lane and toward approaching traffic.
3. Place the third warning indicator 100 feet in front of the RV in the center of the
lane and away from the traffic approaching from behind.
The hazard-warning flasher provides additional safety if the RV is stopped on the
side of the roadway and presents a possible hazard to other motorists. When the
flasher is on, it serves as a warning to others to approach and overtake your
vehicle with caution.
For personal safety, always stand off the road and out of the way of traffic.
Curves and/or hills may affect the safe placement of warning indicators
EMERGENCY TOWING
If your RV needs to be towed, please contact an emergency road service provider
or a qualified service facility for assistance.
LEVELING THE RV
Now that you have parked your RV, you need to ensure it is level. Leveling is very
important. A level RV is more comfortable for sleeping and walking.
The refrigerator is designed to operate when level for best performance due to the
absorption system. The water drainage systems are designed with proper slope
and must be level for proper operation. The appliances perform best when level.
STABILIZER JACKS
1. Each stabilizer jack can be individually adjusted to stabilize the trailer for use.
2. When setting your RV up on soft ground, you may wish to place a wood pad
or the equivalent under each stabilizer jack foot. This will help keep the
stabilizer jack from sinking into the ground.
Manual stabilizer jacks (if so equipped)
To lower each jack, insert the jack crank onto the applicable stabilizer jack shaft.
1. To lower each jack, insert the jack crank onto the applicable stabilizer jack
shaft.
2. Turn the crank clockwise to lower each leg until it contacts the ground and
stabilizes the trailer.
To raise each jack, insert the jack crank onto the applicable stabilizer jack shaft
and turn the crank counter-clockwise.
WARNING
Never allow anyone to go under the RV while it is being lifted and/or
being towed.
To Next Page
Loading...
Need help?
General
