The termination valves for your holding tanks are located on the exterior of the trailer close
to the drain pipe.
Refer to the images indicated in the “Preparing to Travel Home...” chapter.
When hooked up to the sewer drain line at a campsite, keep the termination valve on the
waste tank CLOSED until the tank is at least 3/4 full. This will provide sufficient water to
assist in complete draining of the tank. At this time, open the termination valve to empty
the tank (see directions for draining below) and close the valve when the tank is empty.
Repeat this process as needed, but NEVER leave the termination valve open when hooked
up to the park’s sewer system.
To Connect the Trailer for Waste Disposal
1. Make sure the unit is as level as possible to aid with drainage.
2. Attach the adapter to the flexible sewer hose and secure it with a clamp.
3. Remove the dust cap and attach the adapter onto the drain pipe.
4. Turn the adapter 10° to lock it onto the pegs on the drain pipe.
5. Place the other end of the hose into an approved sewer system.
6. Open the black tank termination valve to empty the black tank.
7. Open the gray tank termination valve to empty the gray tank, utilizing the water to
rinse the flexible hose.
No-Fuss Flush System (Option)
Your trailer may be equipped with a no-fuss flush tank spray system. This feature provides
hook up for cleaning the interior of the black holding tank. Refer to the tank spray system
manufacturer’s instructions supplied with your trailer for complete operating instructions.
Eagle Conventional Travel Trailer and Fifth-Wheel Travel Trailer 47
Setting Up Camp...
To Next Page
Loading...
