100
1. Canister water lter
2. Outside shower and quick disconnect hose
3. City Water / Tank Fill Valve
4. Pump Switch
5. Macerator ON/OFF switch
6. Black Tank Flush inlet (See Black Tank Flush)
7. Fresh Water Connection inlet
8. Macerator hose and dump connector
There are three types of direct fresh water connections located at the exterior utility center:
Fresh water connection inlet
Black tank ush (see Black Tank Flush)
Clear hose (sanitize / winterize)
The utility center has a water shuto valve located behind the utility center panel (Fig 3).
1. Hot water line drain valve (left side of utility center)
2. Cold water line drain valve (left side of utility center)
3. Siphon valve with clear hose attached for sanitizing and winterizing (left side of utility
center)
4. Water supply valve to canister water lter (upper right of utility center)
5. Drain on oor of utility center
6. Macerator Bypass dump valve (center of utility center)
(See Black and Gray Tank Drain section)
7. Water pump and strainer (left wall of utility center)
8. Located beside the pump on the left wall of the utility
center. It must be turned ON when using the pump to circulate water through the water
lines of the RV. Must be OFF when using pressurized City Water to circulate water
through the water lines. If it is ON when using City Water, it can backll the fresh
water tank through the water pump causing it to overow. If you are using pressurized
water to ll the tank, this valve has no eect ON or OFF.
9. Macerator Emergency Cuto valve (center of utility center)
(See Black and Gray Tank Drain section)
Never leave the motor home unattended while lling the fresh water system.
To Next Page
Loading...
