35
Close the door. The step should retract and lock in the ‘up’ position (under step
light is not on).
Open the door. The step should extend and lock in the ‘down’ position with the
under step light illuminated.
If your step is equipped with an override switch, turn it to the ‘ON’ position. The
step should remain extended with the under step light ‘o’ when the door is closed.
With the step override switch turned ‘ON’, the step extended, and the entrance
door closed, turn the vehicle ignition on. The ignition override system will go into
eect and the step will automatically retract.
Turn the vehicle ignition o and open the door. The step will extend and lock in the down
position. This is the ‘auto extend’ feature. When the vehicle ignition is turned on, the step
will always activate with the door movement, regardless of the step switch position.
Refer to the manufacturer’s owner guide included in your warranty packet for detailed op-
erating and safety instructions.
In the event the entrance door is left open, the light will turn ‘off’
after 5 minutes.
When opening the door from the outside, make sure you are not obstruct-
ing the path of the entrance step. Step deployment takes approximately
two seconds. Keep hands and ngers clear while extending or retracting.
Stepping on a partially extended step can cause
damage to the step frame.
Turning the ignition switch to the “ON” position while the vehicle is
parked will cause the step to retract. Visually conrm the step is fully
extended prior to exiting the vehicle.
Entrance Door
Always hold onto the entrance door when opening or closing it. Damage caused because
you failed to do so is not covered by the
Make sure the entrance door is completely closed and locked when traveling.
Locking the door helps prevent it from opening unintentionally and keeps in-
truders from your recreation vehicle.
To Next Page
Loading...
