81
Clean the solar panel upper surface regularly using a soft cloth or sponge with water and
a mild detergent. Do not use harsh chemicals or abrasive brushes that might damage the
panels’ upper translucent surface.
The solar panel battery monitor is typically located in the pas-
senger side overhead entry door control panel. This monitor
features a 4 digit display and custom icons. Provides com-
prehensive system information including voltage, current,
and temperature. A status LED indicates charging progress
and controller operating state. Three battery state-of-charge
LEDs provide quick reference to the level of charge on the
system battery. Soft buttons allow for easy navigation of the
meter menus. It also features self-diagnostics and error re-
porting for troubleshooting.
Refer to the manufacturer’s manuals for the controller and the monitor which are included
in your warranty packet.
Replacing Light Bulbs
Replacement light bulbs must be the same type, voltage and wattage that is listed on the
lamp xture. Use of incorrectly sized bulbs can overload lamp circuits and may create a re
hazard by overheating the xture.
Before replacing a bulb, be sure the light is o.
To Next Page
Loading...
