49
Climate Control System (Dash)
Your motor home has been equipped with an integrated heating / air con-
ditioning system. It provides windshield defrost, heating and cooling for
the front seat occupants only, and is not capable of heating and cooling the
entire motor home. Refer to the manufacturer’s manual for detailed operat-
ing instructions and tips.System Layout
The heater / air conditioner unit is located beneath the dash in the center or
right side of the vehicle (viewed from driver seat). In most modes of opera-
tion the unit draws in fresh air from the outside and heats or cools it before
discharging the treated air into the vehicle. Only in the mode
does the system draw air from inside the vehicle.
The air conditioning system operates in all modes except VENT, FLOOR,
and OFF. This provides signicant moisture, dust and pollen removal for
enhanced passenger comfort.
Blower motor switch (left side or top) has (4) positions, OFF (0), slow to fast (1-4).
Center switch controls heating and cooling. Maximum cooling is all the way to blue side of
the switch, maximum heat all the way to the red side.
To achieve the maximum comfort in your motor home, the air must be directed where it is
needed. The mode switch (right side or bottom) gives the driver the ability to select where
the air will ow.
When outside ambient temperatures are below approximately
40° F, the A/C compressor may cycle rapidly. Use FRESH AIR mode
instead of A/C in these temperature conditions to cool the interior air
temperature. For operational safety in the event of the loss of vacuum,
the HVAC system is designed to discharge air through the defrost vents to
provide continuous windshield defogging.
To Next Page
Loading...
