54
The ALL RETRACT function is a timed event. Pressing ALL RETRACT will
cause the pump to run in retract mode for 60 seconds (or 90 seconds, depending
on your specic system).
Your leveling system is a microprocessor-controlled system. Proper and adequate
battery voltage and permanent chassis ground are essential.
Your system may be equipped with a manual override option. Refer to the proce-
dure for proper operation of this option. It is better to review this procedure prior
to its actual use.
If a jack comes out of the stowed position while traveling, the system panel will
automatically activate and return the jack to the stowed position.
There are a total of ten (10) LED indicators on the Equalizer Keypad. The functions of these
indicators are detailed below.
POWER LED ON Red when power is ON
OFF when power is OFF
FLASH every 5 sec. in Sleep Mode
JACK LED (4 each) ON Red when Jack(s) are deployed
OFF when jack(s) are stowed
OPERATING LED FLASHING Red w/Auto
Level or All Retract
OFF when keypad is idle or “sleeping”
LOW VOLTAGE LED ON Red when voltage is below 10.5 volts dc
OFF when voltage is above 10.5 volts dc
ENGAGE PARK BRAKE LED ON Red when park brake is not set
OFF when park brake is set
IGNITION ON LED ON Red when ignition is in the ON position
OFF when ignition is OFF
EXCESS SLOPE LED ON Red following an Auto Level attempt, if
system cannot overcome slope
OFF when slope is not excessive
For complete instructions, troubleshooting and safety information refer to the manufac-
turer’s manual online at https://equalizersystems.com/service-and-support/operation-and-
installation-manuals/
If the LOW VOLTAGE, ENGAGE PARK BRAKE, IGNITION ON or
EXCESS SLOPE LEDs illuminate, you have an “error” condition that
must be corrected prior to operating the jacks.
Make sure suspension air bags have deployed after retracting jacks. Visu-
ally check front and rear wheel wells for clearance.
To Next Page
Loading...
