of
ANSI
Standard
A119.2,
The
National Electrical Code
and
Canadian Standards Association.
Your new
Jayco
tent camper
is
equipped with a
15-amp
power cord
to connect from the campground outlet to your camper, the power
cord is pre-wired into the distribution panel with
a
15-amp
overcurrent protection breaker
and
then supplies 120-volt
AC
to
the
J
2-volt
DC
power convertor.
To
prevent
accidental electrical shock, insure that the ground pin
on
the
attachment plug cap is intact to the earth ground through
the
R.V.
park
receptacle. When
plugged
into
a
receptacle with no
provision
for
the third
pin,
use
an
adapter with
a
pigtail
that can
be
connected to the receptacle box, with the grounding circuit
completed through the ground pin or
R.V.
park receptacIe box, any
accidental short
of
a live circuit conductor
will
trip the circuit
breakcr indicating a shorted circuit.
You
should
be
certain that the
polarity
of the external power
is
not reversed,
in
order to avoid
harm
to appliances and personal electrical shock. Polarity
indicators may be purchased
in many electrical and hardware
stores
Plug
-.
ANSI
C73.13
-
120V.
15
Amps.
2
Pole.
3
Wire Grounding
Type
CHANGES,
MBDIFIICATIONS,
AND
ADDITIONS
Anv
changes or additions made after delivery
may
develop
a
haiardous condition.
Be
sure to consult
your
Iocal authorized
dealer. Only qualified electrical technicians should
attempt
to
make
changes, or additions to our electrical system, using only
approved materials and components
and
employing approved
methods of installations.
Extension cords should always
be
a
heavy gauge
of
wire equai to
the
power cord. Usage of' too small a cord
will
result
in
overheating
and
possibiy burning
of
the cord.
DO
NOT
leave
an
unused
portion
of
an
extension cord in a coil as it
will
overheat and
short out wires.
To Next Page
Loading...