SECTION 10 – APPLIANCES JAYCO TOWABLE TABLE OF CONTENTS
10-4
Refer to the grill manufacturer’s user guide for detailed operating and safety
information.
Depending on your model, your grill will be mounted with either a bumper mount system,
or a rail mount on the side of your recreation vehicle.
Bumper mount (if so equipped)
Insert the grill mounting bar (with the pins) into the bracket (mounting tube) on the
rear bumper of the recreation vehicle.
Insert the pin through the hole in the bracket and mounting bar. The pin must be
installed to insure the mounting bar is secure during use.
Tighten the T-handle on the bracket mounted to the bumper.
Set the BBQ grill on the mounting bar by inserting the (2) pegs on the bar into the
grill side mounting brackets. Make sure the mounting bar and the grill are securely in
place before proceeding with the propane connection.
Rail mount (if so equipped)
Hang the grill bracket on the aluminum mounting strip located on the side of the
recreation vehicle.
Open the (2) folding arms on the bracket making sure they lock in position.
Slide the grill onto the (2) arms against the stops. Make sure the grill is fully on the
arms.
Insert the retaining pins into the arms.
To remove the grill, remove the retaining pins and simply slide it off of the bracket
arms. Wait until grill has cooled down before removing it.
WARNING
The BBQ grill must be COMPLETELY COOLED before storing it. The grill
should be cool to the touch before storing. Storing the BBQ grill before it is
completely cool may result in serious injury or property damage.
To Next Page
Loading...
