JAYCO TOWABLE SECTION 10 - APPLIANCES
10-5
Gas BBQ Grill Prep (if so equipped)
Your recreation vehicle may be equipped with a propane “quick-coupler” connection and
support bracket for easy installation of the BBQ grill.
Attaching the “quick coupler” connection
The “quick coupler” is directly connected to the RV propane system. The “quick-coupler”
connection is equipped with a positive shut-off valve.
Place the “quick coupler handle in the OFF position and push back the sleeve. The valve
handle must be OFF to make the connection.
1. Insert the plug and release the sleeve.
2. Push the plug until the sleeve snaps forward, locking the plug into the socket.
3. Turn the handle ON to allow propane to flow to the drop in stove.
CARRY OUT STOVE (IF SO EQUIPPED)
The carry out stove can be used either inside or
outside the camping trailer.
NOTE: Always carry the stove with both
hands.
When used inside the camper, the feet on the
bottom of the stove should be placed in the 4
recessed pockets located on the cabinet top to give
the stove more stability.
When used outside the camping trailer, the stove is
mounted to a rail that is attached to the camping
trailer.
1. Mount the cabinet onto the rail at a 30° angle and slowly lower the outer side until it
is horizontal. If applicable, attach the brace to the underside of the stove and RV
sidewall.
2. Attach the propane system using the “quick coupler” connection (see the following
instructions).
3. Unfold the wind deflectors attached to the lid to prevent the wind from blowing out
the burners.
After use, the stove must be COMPLETELY cooled to avoid injury from handling the
stove when it is hot. Turn off the propane valve, disconnect the propane hose. Fold up the
stove and return it to its storage location inside the RV.
NOTE: Wait until the stove is completely cooled, before trying to move or store it.
Attaching the “quick coupler” connection
The “quick coupler” is directly connected to the RV propane system. The “quick-coupler”
connection has a positive shut-off valve as required by code and standards.
To Next Page
Loading...
