JAYCO TOWABLE SECTION 4 – VEHICLE OPERATION
4-13
Power Lift system (if so
equipped)
Press the key FOB continuously
to raise the roof OR press the
power roof switches located just
inside the entrance door. Both
switches must be pressed at the
same time for the roof to operate.
Manual Override for Power Lift:
If the Power Lift system fails to operate,
the roof can still be raised by operating
the lift system with an electric drill inserted
into the access hole located at the rear of
the trailer.
Step 4
Before pulling out bed, make sure
slideout (if so equipped) portion of
tent is pulled out of the way.
There are 2 types of bed brace systems, a bumper mounted system and a hitch mounted
system. If your camping trailer has slots on the bumper, the braces should be set up using
the bumper mounted procedure. If there are slots on the hitch of your camping trailer, you
will need to use the hitch set up procedure.
BED BRACE SET UP: BUMPER MOUNT (If So Equipped)
Step 5 – bumper mount
Locate the front bed support poles
set. “Unfold” or extend the front
pole set. Install the “hook” end of
the front pole set over the top rail of
the front wall.
NOTE: The front and rear poles
are not interchangable.
To Next Page
Loading...
