SECTION 4 – VEHICLE OPERATION JAYCO TOWABLE TABLE OF CONTENTS
4-18
Step 12
Place the bed flap over the edge of the bed
Step 13
Repeat Steps 10 thru Step 12 to set up the rear bed.
Step 14
Front bed – pull the side bed flap down over
the edge of the bed and attach it to the velcro
underneath the bed. Repeat on the other side
of the front bed. Repeat step 14 on the rear
bed.
Step 15
Velcro the slideout tent sides to the
slideout (if so equipped). Snap tent
snaps to unit (arrow).
Adjust for water run-off.
LIFT COVER SET UP
Step 16a – bumper mount system
Install the metal support(s) over the (2) lifter posts at opposite corners of the camping
trailer. Wrap and Velcro the lifter post covers in place.
To Next Page