62
10. Place the rear bed bow brace in the folded FRONT
bunk mat for storage. Store the bunk mat between
bed platform and the interior wall. You will need
to slide one end in rst and bend the mat to secure
it in place.
If the bed does not close easily, inspect the bed cushion from the
sides looking for obstructions. Once the obstruction is located, lower the
bed board, correct the obstruction and try again.
Heated bed mats (if so equipped) should not be stored between the wall and
bed platform. Storing them in a tight space or in a twist or bind may result in
damage to the heating elements. See Section 12; Heated Bed Mats for more
information.
Awnings (if so equipped)
Keep your awnings clean and in good condition to prevent costly repairs.
Periodically check that the fasteners are tight. Tighten if necessary.
Keep the awning fabric clean. For detailed cleaning information, refer to the
manufacturer’s owner information.
Your recreation vehicle may include one or more of the following options:
Power window awning
Slide out awnings
Power awning over entrance door
The eects of wind and rain on an awning are unpredictable and can cause
severe damage to the awning and/or the recreation vehicle. Retract the awning
if:
If wind or extended periods of rain are expected
If you leave the RV unattended for a length of time, to avoid unexpected
climate conditions.
Awnings must be closed (and locked if applicable) while the RV in transit.
To Next Page
Loading...
