89
(C) buttons. Select the back arrow (A) to
return to the Device Selection screen
Select the LEVELING icon, the
screen opens showing the Leveler Control screen (
). This screen will allow you to extend and retract
the jacks and to auto level the RV. Press the
button (A) to begin leveling the RV.
Refer to the Lippert User Guide for the One Con-
trol system for more detailed information. Select the
HOME icon (upper right) to return to the Device Se-
lection screen.
Select the SLIDES icon which
will open the Slideout screen (). The screen can
display up to 4 slideouts. Slideouts will be numbered
1-4 on the touchscreen. Press Slide 01, and then press
(and hold) the (A) button to extend the slide,
or the (B) button to retract it. Repeat this action
on the remaining slideouts. Select the back arrow to
return to the Device Selection screen.
This indicates there is a problem with the bedroom
slide-out. In order for the slideout to function
properly, the bedroom door .
An electronic door catch has been installed to the
wall in the bedroom behind the door (). A
second piece is mounted to the door (). If
the door is closed, the Slide 01 notication on the
touchscreen display will disappear and the slide-
out will NOT operate. When the bedroom door is
opened and the catch pieces connect, the Slide 01
notication appears on the touchscreen display and the slide-out can
then be operated normally.
This light above the GAS water
heater switch on the Command Center panel indicates a problem with the LP portion of the
water heater. When the GAS switch is turned on, the light will blink quickly 3 times and the
water heater will ignite. The light should then stay OFF. If the light comes on and stays
on, it indicates the gas side of the water heater has not red and there is a problem with the
igniter. There is no water heater switch on the app screen.
This same safety feature applies to the slide-out switch on the wall
or on the Command Center switch panel. The bedroom door must be open
and the catch pieces connected for the bedroom slide to work.
To Next Page
Loading...
