119
8. Set the water valves to WINTERIZE setting, and connect a hose to the City Water Inlet.
Insert the other end of the hose into a container of RV antifreeze. Turn the pump ON.
Antifreeze will be drawn into the water lines and xtures (pump only runs when a fau-
cet or xture is open).
9. Turn the water pump ON with the pump switch on the utility center panel. Antifreeze
will be drawn into the water lines when a xture in the RV is opened.
10. Open the hot water line faucets (kitchen/bath sinks, shower (if so
equipped) until RV antifreeze begins to ow continuously.
11. Close the hot water line faucets and repeat with the cold water line faucets (kitchen/
bath sinks, shower ).
Toilet: Flush the toilet several times until you see antifreeze in the bowl.
12. Turn the water pump OFF with the switch on the utility center panel.
13. Colored valves should remain in the WINTERIZE positions.
14. Remove hose & container from the City Water Fill inlet. Put the cap back on the City
Water Fill inlet. Leave the valves in WINTERIZE position.Pour 1 cup of RV antifreeze
into any/all drain P traps (sinks and bathtub).
15. Wipe any RV antifreeze out of the sinks, shower (or tub), toilet, washing machine tub,
and dishwasher tub with a soft, dry cloth.
Contact your dealer if you require further assistance.
1. Pour RV antifreeze into the toilet and down into the black water tank.
2. Turn the macerator pump ON.
3. Run the pump until antifreeze begins to discharge from the dump connector attached
to the ex hose.
When set to :
antifreeze will not enter the water heater
or the fresh water tank. There are no
dedicated water heater bypass valves.
Water can accumulate in the exible hose and dump connector of the macera-
tor system. When winterizing the RV, antifreeze must be added to the macera-
tor system.
Use a container (bucket) for capturing system uid.
To Next Page
Loading...
