31
Wheel Lug Nuts/Wheel Liners
Torque is the amount of rotating force applied to a lug nut, and can only be achieved by using
a properly calibrated torque wrench and socket. Do not use a 4-way socket or any other type
of wrench that does not measure the actual pressure applied to the lug nut.
After your rst trip, check the wheel lug torque periodically for safety according to your
Chassis Guide. If you suspect the wheel lug nuts have loosened at any time, have them
checked and torqued to the proper limits immediately.
Lugs should be checked:
After winter storage
After a wheel removal
Before starting a trip
Following extensive braking.
Refer to the Chassis Guide for torque guidelines.
If you suspect or notice the wheel stud bolts are cracked or broken, they must be replaced,
along with adjacent bolts that have probably also been weakened due to the additional stress
placed on them.
Check and tighten the wheel lug nuts regularly to ensure they did not
loosen during travel. Refer to your Chassis Guide for torque recommen-
dations.
Failure to tighten and maintain wheel lug nuts to the proper torque speci-
cation, could allow the wheels to come o while driving, resulting in
serious injury or property damage in the event of a collision or loss of
vehicle control.
performance and prevent uneven tire wear as part of your normal maintenance.
After this road test has been completed, front-end alignment and/or vibrations will not be
covered as part of the new vehicle limited warranty.
Follow the Chassis Guide maintenance instructions for the front and rear axle for wheel and
suspension maintenance, including the brakes and wheel bearings. Contact your Chassis
manufacturer for assistance.
To Next Page
Loading...
Need help?
General
