43
Power Awning 10.0 AMPS*
Power Vent 5.0 AMPS
Refrigerator 3.0 AMPS
Step Cover 10.0 AMPS*
TV Plate/Antenna Booster 1.0 AMP
Water Heater 6.0 AMPS
Water Pump 7.0 AMPS
*Momentary Load
12 Volts: Labeled watts divided by 12 = Power consumed in AMPS
120 VOLT SYSTEM
Air Conditioner 18 AMPS
Coee Maker 6-12 AMPS
Converter (each) 8 AMPS
DVD System 3 AMPS
Fireplace 15 AMPS
Hair Dryer or Curling Iron 10-14 AMPS
Microwave 15 AMPS
Satellite Receiver 2 AMPS
TV 2-4 AMPS
Vacuum Cleaner 8 AMPS
Washer/Dryer 12 AMPS
Water Heater 12 AMPS
120 Volts: Labeled watts divided by 120 = Power consumed in AMPS
Starting the Generator
Your motor home has a touchscreen to control the generator and manual switches located
in the door area. There is a secondary switch located on the generator itself. An hour meter
that keeps track of generator hours used is located on the touchscreen and a separate hour
meter on the generator.
1. At either “START/STOP” switch, press and hold the start portion of the switch to start
the generator. Depending on the outside temperature the start process can take up to 15
seconds. Once the generator starts running, release the switch.
2. An LED above the start switch will light when the generator is running.
3. For better performance and engine life, especially in colder weather, let the generator
engine warm up for two minutes before turning “ON” 120-volt appliances.
For more information on generator operation and maintenance, refer to the manufacturer’s
owner’s manual.
Your motor home models is equipped with an Automatic Generator Start system (AGS).
The controls are built into the touchscreen system. When enabled, the Automatic Generator
Start system will automatically start and stop the generator according to operator or factory
pre-selected parameters.
Refer to the AGS Start section or the Touch Screen User Guide (in your warranty packet)
will give detailed instructions on the Automatic Generator Start.
To Next Page
Loading...
Need help?
General
