12 13
6. 3 OPEN MENU
To enter the menu, there is a „secret“ position on
the rotary knob, exactly between the the „AUTO“
and „MAN“ modes (see figure).
lf you want to get into the menu, the rotary knob must be set to the
position shown between „AUTO“ and „MAN“.
a. 1 LED in the lower row lights up blue
when the position has been found.
b. Hold position for 5 seconds until all 5 LEDs light up blue.
c. Turn the rotary knob back to „MAN“.
6. 1 SELECT DRIVING MODE
Before switching the mode, the power regulator has to be at the very
bottom on the lowest level. lf the power regulator is NOT at the lowest
level, the LEDs indicate with left running red LEDs that the regulator
should be pushed down to activate the new driving mode.
„AUTO“ In the automatic function, the E-Fin supports the paddle stroke. Through the
power regulator, the assisting force can be set strong (slider up) or weak
(slider down).
„MAN“ When driving manually, the E-Fin responds permanently to the power control.
„OFF“ The control is switched off.
6. 2 ADJUST POWER
By moving the power control you change the power.
6. INSTRUCTION
lowest power.
medium power.
highest power.
To confirm the selection, the rotary knob must be turned to the
„secret“ position and back to „MAN“.
6. 6 MENU ITEM 2: PAIR E-FIN(S)
Up to 5 fins can be connected to one remote.
a. the E-Fin can be connected with the remote now.
b. Now the charging cable MUST be removed in order to connect the fin
to the remote. After approx. 2 seconds:
c. The E-Fin is connected with the remote now.
6. 4 NAVIGATE MENU
To navigate through the menu, the power controller must always be
pushed up and back again. As a result, the red LED moves one field
each time.
shows what menu you are in.
indicates that you are in the main menu.
To get into the submenu, the rotary knob must be turned to the
„secret“ position and back to „MAN“.
6. 5 MENU ITEM 1: SELECT POWER LEVEL
In this submenu you can choose between three
power levels by sliding the power controller up and
down again. The upper row of LEDs then shows:
Note: Parental control
This position is not marked and
is only found by active search.
Important: The E-Fin(s) must ALWAYS be plugged
into the charger before connecting.
To Next Page
Loading...