To Next PageTo Next Page
Need help?Do you have a question about the JB Systems beat 6 mk2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Crossfader | Yes |
| EQ | 3-band |
| Outputs | RCA, 1/4" headphones |
| Microphone input | Yes |
| Inputs | 2x Line/Phono (RCA), 1x Microphone (1/4" Jack) |
Dispose of the unit and used batteries in an environment friendly manner according to your country regulations.
Highlights key features of the unit, including input/output capabilities and special functions.
Instructions for checking the unit for damage, keeping the manual, and recycling packaging.
Verify that the carton contains the mixer, mains cable, and operating instructions.
Follow all safety instructions and warnings to prevent electric shock, fire hazards, and unit damage.
Install in a well-ventilated area, avoid heat sources, and consider mounting options and ventilation.
Clean the unit by wiping with a damp cloth; avoid volatile liquids.
Details on cinch connections and recommendations for quality cables to ensure good audio quality.
Details on DJ mic input jack, gain, tone controls, panpot, and volume for the DJ microphone.
Explains the talkover function to mute channels and PFL selector for headphone monitoring.
Describes channel faders for level control and VU meters for monitoring input signal levels.
Selects the correct input type (Phono, Line, Aux, Mic) for each channel.
Adjusts input levels to 0dB and controls channel frequencies from -26dB to +12dB.
Displays BPM, synchronizes beats, and controls CD player start/stop via crossfader.
Mixes channels using the fader and integrates optical fader starts.
Adjusts output levels and balance for Master 1 and Master 2 outputs.
Monitors Master 1 output levels and allows switching masters between mono and stereo modes.
Mixes master output with selected channels for headphone monitoring and controls headphone level.
Turns the mixer on/off; blue LED indicates when the mixer is powered.
Details mains cable input, balanced/unbalanced master outputs, and record output.
Explains connections for line, turntable, and microphone inputs on channels 2 through 5.
Switch for mic2/CD1 input on channel 2 and line/mic input on channel 1.
