29
Operation in Master-Slave mode:
To set a fixture to slave-mode navigate to
To activate the slave funciton p
The display will show either REMOTE INACTIVE if no DMX-signal is being
received or REMOTE ACTIVE if a DMX-signal is being received.
To leave this fuction press “ESC” (keep it down) and press “ENTER” in addition.
Connect the A12 with DMX cables.
Select with the master fixture. Start function by pressing “ENTER”
(keep it down) and pressing “ESC” in addition.
All connected fixtures will repeat the steps synchronized to the master fixture.
To leave the menu press “ESC” (keep it down) and press “ENTER” in addition.
If you realize that a fixture reacts inaccurate check if the display shows REMOTE ACTIVE.
REMOTE.
STANDALONE/RUN
ress “ENTER” (keep it down) and press “ESC” in addtion.
Activate the standalone mode:
The standalone mode is activated in the menu
To enter the functions press “ENTER” (keep it down) and press “ESC” in addtion.
The A12 will execute sequence in a repeating loop.
To leave press “ESC” and hold it down and press “ENTER” in addition.
STANDALONE, RUN.
With one step of the sequence can be deleted. Chose the step and confirm the
function with ENTER.
To reset the DMX values of a step use . Select the step and confirm with
“ENTER”. All DMX values of the step will be set on zero.
With the complete sequence will be deleted and the display will show
DELETE
RESET STEP
CLEAR ALL
STEP 01/01.
Store cues from a DMX board:
The DMX values can also be programmed by means of a DMX console.
Enter the menu and navigate to . Programm the DMX-values
with an external DMX-console. To capture the data press „ENTER“. The fixtures display
will show . To insert, delete or reset use the keys of the control panel
of the fixture.
STANDALONE CAPT DMX
START CAPTURE
To Next Page
Loading...
