Need help?Do you have a question about the JBL L20T3 and is the answer not in the manual?
General| Brand | JBL |
|---|---|
| Model | L20T3 |
| Category | Speaker System |
| Language | English |
Connect amplifier or receiver to loudspeakers using appropriate wire gauge for distance.
Minimum #18 AWG for 50ft, #16 AWG for 100ft, #14 AWG for 200ft.
Arrange speakers symmetrically for best stereo imaging, typically at 40°-60° angles.
Bass response is affected by proximity to walls and corners.
Recommended 200W for L20T3, 400W for L100T3 for full dynamic range.
Avoid amplifier clipping and distorted signals to protect drivers.
Contact authorized JBL dealer for warranty service, bring sales receipt.
Grasp grille corners and pull gently to remove pins.
Remove from front baffle after unscrewing four Phillips-head screws.
Remove after low frequency driver; secured by four screws.
Do not attempt to remove; return entire unit to dealer if malfunctioning.
Extra high density composite, lock mitred, rock solid, free from resonances.
Oil/wax preparation; clean with damp cloth for stains, soft brush for grille.
To Next Page
