CONNECTING
THE LX11 Emerging from the
chassis
of the LX11 network are four wires: two
black, one
green
and one red.
Connect
the
green
wire
to the red terminal
post
of the LE10A low
frequency
loudspeaker.
Connect
the red wire to
the red terminal
post
of the LE20 high frequency
transducer.
Connect
the black wires to the black
posts
of the
speakers.
Since
these
two wires are
connected
in the internal circuitry of the
net-
work,
either
black wire may be
connected
to
either
speaker.
CONNECTING
THE LX8 The LX8 network is
connected
in the
same
way as the LX11.
Connect
the
green
wire to the red terminal
post
of the
LE14A
low frequency
loudspeaker.
Connect
the
red wire to the red terminal
post
of the LE20 high
frequency
transducer.
Connect
the black wires to
the black
posts
of the
speakers
—
either
wire to
either
speaker.
CONNECTING
THE N400, N1200, N2400 and LX2.
Each
of
these
four dividing networks is
connected
as
shown in the diagram below:
CONNECTING
THE LX5, LX13, and LX10.
These
networks are
connected
to
speakers
as shown in the
diagram below:
Extended Range
or low frequency
speaker
High frequency
transducer
network
To Amplifier
Low frequency
speaker
High frequency
transducer and
horn or horn/lens
Network
To Amplifier
To Next Page
Loading...
