3
Setting Up a Single Speaker with No Wi-Fi Router
1. Download the app from www.jblpro.com then install it
2. Power on all PRX800W speakers in your setup
3. The application will display a welcome screen — select “SKIP”
4. Go to the back of the speaker and set it to Access Point mode by pressing and holding the CONNECT
button for 2 seconds — the CONNECT LED will begin ashing slowly
5. Go to your tablet’s Wi-Fi settings and select any network labeled PRX800 xx.xx.xx
6. Come back to the PRX Connect application and begin setting up the show
Re-Enter or Change Wi-Fi Information
1. From the top left-hand menu, select Wi-Fi
2. Follow steps 7–13 of the Wi-Fi setup instructions above
To Next Page
Loading...
Need help?
General
