Need help?Do you have a question about the JBL S4700 and is the answer not in the manual?
General| Type | 3-way floorstanding speaker |
|---|---|
| Impedance | 6 Ohms |
| Power Handling | 300 Watts RMS |
| Nominal Impedance | 6 Ohms |
| Sensitivity | 94dB |
| Tweeter | 1" (25mm) compression driver with aluminum diaphragm |
| Low-Frequency Transducer | 15" (380mm) |
| Crossover Frequencies | 800Hz |
| Enclosure Type | Bass-reflex |
| Connector | binding posts |
Important considerations for speaker positioning and avoiding damage.
Connect the amplifier to each speaker using a single wire.
How to connect using bare wires or pin connectors to the terminals.
How to connect using spade connectors to the terminals.
How to connect using banana connectors to the terminals.
Connecting speakers for bi-wiring with one stereo amplifier.
Connecting speakers for bi-wiring with two stereo amplifiers.
To Next Page
