11
SELECTING FULL-RANGE CONFIGURATION
There Are Two Ways to Select Full-Range LCR Operation.
Please Note: Only Method One can be done on the control ports
(without a computer). Method Two requires a computer running
the appropriate configuration software. Please contact JBL
Synthesis Technical Support for more information.
METHOD ONE:
With the unit powered up and running, connect Control Input 1
to “C” (common) on the back of the unit for full-range.
METHOD TWO:
While online and in operate mode from within London
Architect, select the “Main” page and then click on the
full-range button.
SELECTING BI-AMPED CONFIGURATION
There Are Two Ways to Select Bi-Amped LCR Operation.
Please Note: Only Method One can be done on the control ports
(without a computer). Method Two requires a computer running
the appropriate configuration software. Please contact JBL
Synthesis Technical Support for more information.
METHOD ONE:
With the unit powered up and running, connect Control
Input 2 to “C” for bi-amped.
METHOD TWO:
While online and in operate mode from within London
Architect
™
, select the “Main” page and then click on the
bi-amped button.
INPUT/OUTPUT ASSIGNMENTS
NOTE: The full-range configuration is the default and will
not require selection during normal use.
To Next Page
Loading...
