jcb 19c-1 EP

1
Compact Excavators
18z-1, 19c-1, 19c-1 EP
Quick Start Guide
QUICKSTART.JCB.COM

jcb 19c-1 EP Specifications

General

Brand	jcb
Model	19c-1 EP
Category	Excavators
Language	English

Summary

Dimensions

Tie Down Points

Lifting Points

Instrument Panel

Start Up Sequence

Step 1: Insert Isolator Key

Procedure for inserting and turning the isolator key.

Step 2: Raise LH Arm Rest

Ensuring the hydraulic isolation lever is in the raised position.

Step 3: Engage Seat Belt

Procedure for engaging the seat belt before starting the machine.

Step 4: Engine Pre Heat

Turning ignition for pre-heat and waiting for the symbol to go off.

Step 5: Disarm Immobiliser

Procedure for disarming the immobiliser using a PIN code.

Step 6: Start Machine

Turning ignition to start the machine.

Step 7: Lower LH Arm Rest

Lowering the arm rest to activate hydraulics.

Step 8: Press 2 GO Button

Pressing the 2 GO button to activate hydraulics and illuminate the panel.

Step 9: Operate Machine

Confirmation that all controls are active and the machine is ready.

Hydraulic Hitch Unlock Sequence (19 c-1 EP only)

Step 1: Start Unlock Process

Initiating the quick hitch unlock process by pressing the sequence button.

Step 2: Confirm Process

Confirming the process via the instrument panel and 2 GO button.

Step 3: Boom LED Indicator

Confirmation of process by a red flashing LED on the boom.

Step 4: Remove Attachment

Disengaging the pivot pin and removing the attachment.

Step 5: Change Attachment

Engaging the jaw with a new attachment and aligning the latch.

Step 6: Lock Quick Hitch

Engaging the lock on the quick hitch and visually checking.

Mechanical Hitch Unlock System

Step 1: Park Machine Up

Parking the machine on firm ground with attachment and dozer positioned.

Step 2: Disconnect Attachment

Stopping the engine, removing hydraulic hoses and locking pin.

Step 3: Insert tommy bar

Inserting the tommy bar into the latch hook.

Step 4: Release Attachment

Applying pressure to the tommy bar to release the rear pivot.

Step 5: Restart Machine

Step 6: Remove Attachment

Shutdown and Auxiliary Venting

Shutdown Sequence: Park Machine Up

Shutdown Sequence: Leave & Secure

Shutdown Sequence: Isolate Machine

Auxiliary Venting: Lower LH Arm Rest

Auxiliary Venting: Turn Ignition On

Auxiliary Venting: Press 2 GO Button

Auxiliary Venting: Select Aux Circuit

Auxiliary Venting: Switching Circuits

Auxiliary Venting: Venting Aux Circuit

Maintenance Position

Step 1: Park Machine & Levers

Step 2: Lower Dozer Blade

Step 3: Position Attachment Flat

Step 4: Stop Engine

Step 5: Discharge Hydraulic Pressure

Step 6: Isolate Controls

Step 7: Isolate Battery

ServiceMaintenance

Fluids and Lubricants

TroubleshootingFAQs

Machine will not start

Troubleshooting steps for when the machine fails to start.

Cannot activate Hydraulics

Reasons and solutions for hydraulics not activating.

Switching control patterns

Activate continuous auxiliary flow