JCB-PW7532P
Instruction & User Manual
20
Operation
Starting
> Turn the ignition switch to the ON position
> Pull the recoil starter grip lightly until resistance is felt, then pull it briskly. Do not allow the recoil starter grip to
snap back against the engine. Return it gently to prevent damage to the starter.
> If the choke lever was moved to the CLOSED position to start the engine, gradually move it to the OPEN
position as the engine warms up.
> Pump output is controlled by adjusting engine speed. Moving the throttle lever in the FAST direction will
increase pump output, and moving the throttle lever in the SLOW direction will decrease pump output.
Ignition Switch
Recoil Starter Grip
Choke Lever
Throttle Lever
Slow
Fast
Open
On
To Next Page
Loading...
Need help?
General
