NSTALLATION
Amplifier racking size for PA series are designed for standard 19"
right panel of rack system by additional bracket.
Never block the air vents rear and front of the amplifier, The following
is figure of air-flow. Check inside temperature of rack system so as
COOLING
IMPORTANT NOTICE: Fix amplifier to the left panel and the
MOUNTING
not to be more than 40 C for the stable operating in any case, we
recommend you to install cooling fan additionally on the rear panel
of rack cabinet.
I
rack mounting. Please pay close attention to the cooling requirements.
표준19"랙에장착할수있는구조로설계되어있으며,방열에필요한
결합하여랙캐비넷의후면과견고하게고정되어야합니다.
앰프의전면과뒷면에있는공기구멍을절대막지말아주십시오.
앰프냉각구조의공기흐름은아래그림과같은형태입니다.
방열
중요사항:제품의무게때문에후면좌,우판넬은보조브라켓을
랙조립
안정된운용을위해서는랙내부온도가40C를초과하지않도록
신경을쓸필요가있으며,냉각효과를증가시키기위해랙뒷벽에
송풍기를부착하여주십시요.
통풍구조에신경쓸필요가있습니다.
AMP-1
fault
protect
cliping
signal
power
priority
AMP-2
fault
protect
cliping
signal
power
priority
AMP-3
fault
protect
cliping
signal
power
priority
fault
protect
cliping
signal
power
priority
AMP-
4
424DPT
PA-
4 CHANNEL P.A POWER AMPLIFIER
POWER
Stand-by
8
To Next Page
Loading...
Need help?
General
